Installation on Timber

SD1

Stainless steel edge fitting

SD2

Cast bronze edge fitting

SD3

Cast aluminium edge fitting

SD4

Brass round

Skateboard Deterrent SD4 SD4 Skateboard Deterrent Brass Round

SD5

Stainless Steel Round

SD5 Stainless Steel Round Skateboard Deterrent Closeup of an SD5 Skateboard Deterrent Stainless Steel Round

SD8

Stainless steel edge insert, folded plate

Skateboard Deterrent Stainless Steel folded plate SD8 SD8 Skateboard Deterrent Stainless Steel edge insert folded plate closeup

Installation on Concrete

SD6

Stainless Steel Insert

SD7

Stainless steel edge insert

Recommendations

On Seats 1800mm long with Arms:
Recommended number: 2 Installed 600mm from seat sides

On Seats 1800mm long with No Arms:
Recommended number: 3 Installed 300mm from seat sides & one in the centre

On Benches 1800mm long
Recommended number: 3 per exposed side 300mm from seat sides & one in the centre

On Seats and Benches longer than 1800mm
300mm from seat sides & approx. 600mm apart along centre Per each exposed side

Warning

As each situation is unique, recommendations above are for general reference only. It is the responsibility of the customer to determine the optimum number of skateboard deterrents to be used and to ensure correct installation (unless installed by fel. Group Limited). fel. Group Limited is not responsible should any vandalism occur due to skateboarders.

 

Skateboard Deterrent Installation

 

 

Contact Us

373 Neilson Street, Penrose, Auckland